User`s manual

4
3. I/O Signals and Remote Register Assignment
3.1 I/O Signals Transferred to/from the Master Module
The following table lists the I/O signals assigned to the GOT.
The I/O signals differ according to the set number of occupied stations (1
or 4 stations).
n in the table indicates the address assigned to the Master module by
station number setting.
*1 : The remote READY flag is on during startup of the GOT.
It switches on when GOT power is switched on, hardware reset is
made, or the GOT is ready to operate.
If GOT power is on, the remote READY flag is off when offline
operation is performed (during OS installation or screen data
downloading) or while initial processing is executed.
Use it for the interlock ladder when writing or reading data to or from
the CC-Link Master station.
Signal Direction: GOT Master module Signal Direction: Master module GOT
Device No.
Signal name
Device No.
Signal nameNumber of occupied stations Number of occupied stations
1 station 4 stations 1 station 4 stations
RXn0 to RXnF
RXn0 to
RX(n+6)F
User area RYn0 to RYnF
RYn0 to
RY(n+6)F
User area
RX(n+1)0 to
RX(n+1)A
RX(n+7)0 to
RX(n+7)A
Reserved
RY(n+1)0 to
RY(n+1)A
RY(n+7)0 to
RY(n+7)A
ReservedRX(n+1)B RX(n+7)B
Remote
READY flag
*1
RY(n+1)B RY(n+7)B
RX(n+1)C to
RX(n+1)F
RX(n+7)C to
RX(n+7)F
Reserved
RY(n+1)C to
RY(n+1)F
RY(n+7)C to
RY(n+7)F