Specifications

2 - 10

2.3 Preparatory Procedures for Monitoring

2.3.6 Verifying GOT recognizes controllers

2.3.6 Verifying GOT recognizes

controllers

Verify the GOT recognizes controllers on [Communication

Settings] of the Utility.

• Channel number of communication interface,

communication drivers allocation status

• Communication unit installation status

Remark

How to display Utility (at default)

When setting the utility call key to 1-point

When setting [Pressing Time] to other than 0 second

on the setting screen of the utility call key, press and

hold the utility call key until the buzzer sounds.

For the setting of the utility call key, refer to the

following.

GT User's Manual

When using GT1595 or GT1020

Utility call key

1-point press on GOT screen upper-left corner

Simultaneous 2-point press

(When using GT15)

Utility display

When using GT1585, GT157 ,

GT156 , GT155 , GT11 or GT1030

(When using GT11)

(When using GT10)

1 After powering up the GOT, touch [Main Menu]

[Communication setting] from the Utility.

2 The [Communication Setting] appears.

3 Verify that the following communication driver

name is displayed in the box for the

communication interface to be used.

• Communication driver:

ALPHA2

When the communication driver name is not

displayed normally, carry out the following

procedure again.

Section 2.3 Preparatory Procedures for

Monitoring