Specifications

Easy Operation
High Performance
Global Standard
10
Connections with peripheral equipment (Note 1)
Peripheral equipment is connected to MR-E Super as described below.
Connectors, options, and other necessary equipment are available so that users can set up MR-E Super easily and begin using
it right away.
RS T
CN1
CN3
CN2
XY
C
P
Z
L3
(Note 2)
L2
L1
FX 2N -10GM
FX
2N -20GM
FX
2N -1PG
FX
2N -10PG
QD75P
P1,2,4
QD75D
D1,2,4
A1SD75P
P1 to 3
CNP2
CNP1
Notes:
Used to protect the power
supply line.
Circuit breaker
(NFB)
Power supply
3-phase 200-230VAC
or
1-phase 230VAC
(Note 2)
Used to turn off the servo
amplifier’s power when an
alarm has been triggered.
Magnetic contactor
(MC)
Power factor
improvement
reactor
(FR-BAL)
Optional regeneration unit (option)
Install this unit in situations involving fre-
quent regeneration and large load iner-
tia moments. Connect this unit referring
to “MR-E-MA/AG-KH003 INSTRUCTION
MANUAL”.
Display panel
Setting section
Displays monitoring data, parameters,
and alarms.
Parameter settings and monitoring
etc. are executed with push buttons.
Servo amplifier
MR-E-MA/AG-KH003
Control signal
connector
CN3 for RS-232C communication (option)
Monitoring, batch parameter entry and saving, graph
display and test operation can be performed with MR
Configurator (setup software) when connecting to a
user's personal computer. Optional cable is required.
Positioning controllers
Mitsubishi controller or any pulse train
output controller can be used.
Control signal (for operation panel)
Connected to the PLC’s I/O port or the
machine’s operation panel.
Charge lamp
Illuminates when the main circuit power supply
is ON. Do not plug/unplug power lines when
this lamp is ON.
Servo motor
(The picture is of
HF-KE13W1-S100)
1. Refer to “MR-E-MA/AG-KH003 INSTRUCTION MANUAL” for the actual connections.
2. When using a power supply, 1-phase 230VAC, connect the power supply to the L1 and L2 terminals. Do not connect anything to L3.
Peripheral Equipment (standard interface)