Specifications

-
140
-
'10 • SR-T-091
(5) Flap control
Control the flap by AIRFLOW


(UP/DOWN) button on the wireless remote controller.
(a) Flap
Each time when you press the AIRFLOW


(UP/DOWN) button the mode changes as follows.
(b) Swing
1)
Swing flap
Flap moves in upward and downward directions continuously.
(c) Memory flap (Flap stopped)
When you press the AIRFLOW button once while the flap is operating, it stops swinging at the position. Since this angle is mem-
orized in the microcomputer, the flap will automatically be set at this angle when
the next operation is started.
(d) When not operating
The flap returns to the position of air flow directly below, when operation has stopped.
(6) Air outlet selection
(a) AIR SELECTION button can switch between the combination of upper and lower air outlets and upper air
outlet. Not operable while the air conditioner is OFF.
1) Each time the AIR SELECTION button is pressed. The combination of the
upper and lower air outlets and the upper air outlet can be switched.
2) When the upper air outlet is selected, AIR OUTLET SELECTION light on
the unit display area will light green.
COOL , DRY, FAN
Remote controller
display
HEAT
Approx. 60°
Approx. 44°
Approx. 50°
Approx. 32°
Approx. 38°
Approx.
21.5° Approx. 5°
Approx. 21.5°
Approx. 12°
Approx. 12°
󰱛
Angle of Flap from Horizontal
(Swing)
(Flap stopped)
Approx.60°
Approx.12°
Approx.44°
Approx.5°
In HEAT operation In COOL, DRY, FAN operation
AIR OUTLET SELECTION
light : OFF
AIR OUTLET SELECTION
light : ON
Upper air outletUpper and lower air outlets
AIR SELECTION button