Specifications

188
2) Adjusting the unit’s levelness
1 Adjust the out-of levelness using a level vial or by following method.
● Make adjustment so that the relation between the lower surface of the indoor unit proper and water level in the hose
becomes as given below.
2 Unless the adjustment to the levelness is made properly, malfunctioning or failure of the float switch may occur.
3) Tap selection on blower unit
Taps of blower unit are set at the standard selection at the shipping from factory. Where the static pressure is raised by
changing the connection of connectors provided at the flank of control box as shown below.
(f) Installation of decorative panel
1) Case of silent panel
a) Accessory
b) Installation procedures
1 Remove the inner frame of panel
< How to remove the panel inner frame >
● Detach from pins (A) in the order of arrow 1
→
2
● Open slightly as the arrow 3 and move toward the arrow 4 and detach from pin (B)
PVC hose
0 ~ 5 mm
Piping side
Supply water
Water level
Bring the piping side slightly lower.
High speed tap
Red
Blue
Black
White
Blue
Control box side
Motor side
Red
Connector, white
Black
Brown
White
Standard tap (at shipping)
Red
Blue
Black
White
Red
Control box side
Motor side
Connector, white
Blue
Black
White
White
Remove
Panel outer frame
Panel inner frame
Pin (A)
Panel outer frame
Panel inner frame
Pin (B)
Name
Round head machine
screw (M5 x 35)
4 pcs. Securing the panel
Q'ty Position