Specifications

185
2 Mount the two (M5 x 35) panel mounting screws to the indoor unit
3 Hang the panel on the two mounting screws on the indoor unit by using the two shaped holes. Slide the panel approximately 10 mm.
Use the 5 panel mounting screws to secure the panel.
4 Use the opening to connect the connectors for the louver motor and limit switches.
5 Reinstall the wind shield plate.
(c) Installation on higher ceiling
Adhere the insulation materials on the blow outlet of the indoor unit. All others are same as the standard installation.
Detail of Section A
Sliding direction
Ceiling opening
Opening
Connector
Approx. 15 mm
A