Specifications

182

Procedures

1 Install nuts on the Suspension bolts at onside. Suspension the suspension fixtures on the Suspension bolts first and then insert the

remaining fixtures on the remaining Suspension bolts at and lock them with nuts.

2 Since the indoor unit and the panel height cannot be adjusted, adjust the height using an attached pattern before fixing the indoor unit.

c) Fixing of Suspension bolt. Fix the bolts securely as shown below or by any other adequate means.

d) Installation

Insert

Concrete

Suspension

bolt, M10

Hole-in anchor bolt

Hole-in plug

Unit

Duct connection opening

for blowing through

lowered ceiling.

Drain pump box

Suspension fixture (4 places)

Detail - Section A

Ceiling board

Panel mounting hole

Pattern

securing

screw

(attached)

Using the external dimensions shown

on the pattern as a guide, cut out an

opening on the ceiling board.