User`s manual

Operation mode display
The selected operation mode is
indicated.
Operation/check indication lamp
During normal operation: Green
lamp is lit.
When an error occurred: Red lamp
flickers.
ON/OFF switch
This switch performs run/stop of the
air-conditioner. Press switch once to
“run” and press it again to “stop”.
(The switch can be operated without
opening the cover.)
The indicated temperature value
may be different from the indication
of thermometer, etc. but this is not
abnormal.
Preparation of heating
(HOT KEEP) display
See page 9.
Temperature setting/time setting switch
This switch is used to set the room
temperature and the timer time.
See page 5.
Return air temperature display
The temperature of return air is
indicated.
Auto swing switch
Activates and stops the swing flap.
See page 6.
Blow rate switch
The fan speed is switched.
Remote display
This display is indicated when the unit is controlled by
the normal individual remote controller.
(The indication remains intact while the air-conditioner
is stopped, too.)
Center display
This display is indicated when the unit
is controlled by the center console that
is sold separately.
Timer operation display
This display indicates the content of
timer operation.
(The indication remains intact while
the air-conditioner is stopped, too.)
Check switch
This switch is used for service.
Timer switch
This switch is used to select the content of timer
operation. See page 5 and 6.
Setting switch
This switch is used to set the timer time.
See page 5 and 6.
Filter sign
When this display is indicated,
clean the air filter.
See page 7 and 9.
Time display/
indoor unit No. display
Auto swing display
The state of the swing flap is
displayed.
Blow rate display
The fan speed set is displayed.
Setting temperature display
This display indicates the setting
temperature.
Filter reset switch
This switch resets (erases) the filter sign
display.
(Press this switch after the cleaning of
filter has been finished.)
Cover
Mode switch
This switch makes selection of the
operation mode.
N O T E
CHECK
FAN
SPEED
AUTO
SWING
TIMER
SET
MODE
TEMP
TIME
PROGRAMTIMER
SE T TEMP
E
C
LO
HI
FAN
MED
C
Outdoor No.
CENTER REMOTE
AUTODRYCOOLFANHOT KEEP
FILTER
RESET
I
O
O
ON OFF
AM
PM
CONTROLS AND FUNCTION
The illustration below shows the status that the cover is open. The liquid crystal display area indicates the full
contents of display for explanation.
Pull the knob towards you to open the cover downward.
CAUTION
“AUTO SWING” switch are not equipped for FDR, FDUM, FDFL, FDFU series.
FDFL Series FDFU Series
Air outlet
● FDCJ140HKXE2B
● FDCP140HKXE2B
Outdoor Unit
Air outlet
● FDC2001HKXRE2, 2501HKXRE2
● FDCP2001HKXRE2, 2501HKXRE2
● FDCJ224HKXE2B, 280HKXE2B
● FDCP224HKXE2B, 280HKXE2B
Air inlet
Provided on the back of the unit.
Air inlet
Provided on the back of the unit.
4
Remote control
Controls the operation of air conditioner.
Discharge grille
Cool or warm air is blown through
the louver.
Suction grille
Inhales air in the room.
Air filter
Removes dust or dirt from inhaled air.
PSA012B656_E_A3 06.7.28, 6:02 PM4