User manual

Model FD-PAC / FDC200VS
Model
Technical specifications
Control kit Outdoor unit
FD-PAC FDC200VS
Nominal coolingcapacity (1) W 20000 (7000 ~ 22400)
Nominal heating capacity (1) W 22400 (7600 ~ 25000)
Power source 3 fase, 380/400/415V, 50Hz, N, PE
Operation data (3)
Cooling power consumption kW 6,47/6,47
Running current (cooling) A 9,7/10,1
Power factor (cooling) % 96/97
Heating power consumption kW 5,97/5,97
Running current (heating) A 9,1/9,5
Power factor (heating) % 95/95
Inrush current A 5,0
Moise level dB(A) - 57
Exterior dimensions (height x width x depth) mm 400 x 300 x 120 1300 x 970 x 370
Nett weight Kg 8 122
Compressor type - GT-C5150ND79
Compressor motor kW - 4,5
Refrigerant oil L - 1,45 (M-MA32R)
Carterheating W - 40 (carterheating)
Starting method - Direct
Heat exchanger - Air (straight fin)
Defrost control Microprocessor controller de-icer
Refrigerant R410A
Refrigerant amount kg - 5,4 (pre-charged to 30 mtr)
Refrigerant expansion Elektronic expansion valve
Air handling equipment, fan type - Axiaal ventilator x 2
Motor - 120 x 2
Air flow m³/h Min.3000 9000
Air entrance temperature cooling min./ max. °C 16 / 32 -
Air entrance temperature heating min./ max. °C 10 / 32 -
Water entrance temperature cooling min./
max.
°C 16 / 32 -
Water entrance temperature heating min./
max.
°C 10 / 32 -
Safety equipment
-
Internal thermostat for fanmotor,
anomalous discharge temperature
protection
Refrigerant piping mm Liquid line 10mm, Gas line 16mm
Piping size mm Liquid line 9,52 mm (3/8”), Gas line 22,22mm (7/8”)
Connecting method Flare piping
Isolation Necessary (liquid and gasline)
Drain hose mm - Drain pan3x Ø20 mm
Accessoires -
Paneel (separate packing) -
Optional accessoires - -
Remote controller RC-E3 -
Notes
(1) The data are measured at the following conditions.
Item
Mode
Indoor temperature Outdoor temperature
standard
d.b. temp. w.b. temp. d.b. temp. w.b. temp.
Cooling 27°C 19°C 35°C 24°C
ISO-T1, JIS
B8616
Heating 20°C - 7°C 6°C
(2) This airconditioner is manufactured and tested in conformity with the following standards: ISO-T1”unitary
airconditioner”.
(3) The operation data indicate when the airconditioner is operated at 230V, 50hz.
(4) Values in ( ~ ) show the minimum to maximum range.
(5) Adjustment of the estimated output via DIP switch (see page 16).
-10-