Specifications

Graphic Operation Terminal GOT-F900 Start Up 5
5-14
5.3 Each mode selection procedure
[ SELECT MODE ] END
USER SCREEN MODE
ALARM MODE
HPP MODE
SAMPLING MODE
TEST MODE
OTHER MODE
MODE SELECT MENU SCREEN
Production control
Number of products
Operation rate
1234
[ HPP MODE ] END
PROGRAM LIST
PARAMETER
[ SUMPLING MODE ] END
SET CONDITION
DISPLAY LIST
[ ALARM MODE ] END
DISPLAY STATUS
DISPLAY HISTORY
USER SCREEN MODE
HPP MODE
SUMPLI NG MODE
ALARM MODE
• If "MAIN MENU CALL KEY" has been set in
"SET-UP MODE", when a specified touch key is
pressed, the SELECT MODE screen shown on
the left is displayed.
• When using the F920GOT-K, operate the key-
pad as follows:
- Press the DEV key to display MODE SELECT
MENU SCREEN.
• The outline of each mode and the selection
procedure are described below.
• USER SCREEN MODE (Refer to
Chapter 7.)
A user screen is displayed.
Characters such as standard text,
numerics and simple graphic can
be displayed.
• HPP MODE (Refer to Chapter 8.)
Read, write or monitor can be
performed using the list programs.
Bit devices and word devices in the
PLC can be monitored.
Set values of T, C and D can be
changed.
• SAMPLING MODE
(Refer to Chapter 9.)
The current value of specified data
is acquired in a constant cycle or
when the trigger condition is
satisfied.
• ALARM MODE
(Refer to Chapter 10.)
Bit devices are monitored as alarm
elements. When a bit device
becomes ON, a corresponding
message is displayed.