Specifications

Graphic Operation Terminal GOT-F900 Start Up 5
5-9
5.2.7 SET CLOCK
• Set the time used in the time switch, the sampling
mode and the alarm mode.
• The clock data is not built in the F920GOT-K.
On the SET CLOCK screen, set time from the clock
data in the connected PLC. If the clock data does not
exist in the PLC, a number 0 is displayed for each field.
• When "DATE" or "TIME" is selected, date or time can
be entered using the ten-key pad displayed at the bot-
tom of the screen. Enter the desired date or time and
press the ENT key to register it.
• When using the F920GOT-K, operate the key-pad as
follows:
- Press the SET key to start making changes.
- Press the
!
/
$
/
"
/
#
keys to move to another items.
- Press the 0 to 9 keys to enter time.
- Press the ENT key to set time.
- Press the ESC key to complete setting.
5.2.8 SET BACKLIGHT
• Set the time at which the display backlight turns off.
When a touch key is not pressed or the user screen is
not changed over within the specified OFF time, the
backlight is turns off. (Initial: 10 min)
• When "OFF TIME" is pressed, the OFF time can be
set within the range of 0 to 99 minutes using the ten-
key pad displayed at the bottom of the screen. Enter
the desired time and press the ENT key to register it.
• The life of the backlight is 25000 hours.
• The specified bit of the control device (system infor-
mation) should be set to ON so that the backlight OFF
function is enabled. (Refer to Section 6.6.)
• When using the F920GOT-K, operate the key-pad as
follows:
- Press the SET key to start making changes.
- Press the 0 to 9 keys to enter time.
- Press the ENT key to set time.
- Press the ESC key to complete setting.
DATE 3 / 1 / 1999
[ SET CLOCK ]
END
[ SET CLOCK ]
5 6 7 8 9 - CLR
0 1 2 3 4 ENT
TIME 10: 10: 10
OFF TIME 10 MIN.
[ SET BACKLIGHT ]
END
[ SET BACKLIGHT ]
5 6 7 8 9 - CLR
0 1 2 3 4 ENT