Specifications

Graphic Operation Terminal GOT-F900 Start Up 5
5-7
5.2.4 SERIAL PORT
• Set the serial communication parameters for the
printer used to print out alarm messages and sampling
data. (Initial: Left screen)
• Make sure to set "PRINTER" to "USE" when a printer
is connected.
When it is set to "USE", the two-port interface
function is not available.
• The area enclosed with broken lines function as touch
keys. Every time a touch key is pressed, the displayed
setting items change.
• When "LINK PORT (RS232C)" is selected on the PLC
TYPE screen, a printer cannot be connected.
• A bar code reader can be connected. However, if a
printer is connected, the computer link connection
cannot be performed (RS232C).
• This item is not available in the F920GOT-K.
5.2.5 OPENING SCREEN
• Set the duration in units of seconds in which the
OPENING SCREEN indicating the model name, the
version, etc. is displayed immediately after the power
is turned on. (Initial: 4sec)
• When the touch key "DISPLAY TIME" is pressed, the
time can be set using the ten-key pad displayed at the
bottom of the screen.
• Enter the desired display time and press the ENT key
to register the input time.
* If "DISPLAY TIME" is set to "0", the USER
SCREEN MODE is displayed.
It is recommended to set 1 second or more for the
FX Series and 4 seconds or more for the A Series.
• When using the F920GOT-K, operate the key-pad as
follows:
- Press the SET key to start making changes.
- Press the 0 to 9 keys to enter time.
- Press the ENT key to set time.
- Press the ESC key to complete setting.
9600 bps
7 bit
1 bit
[ SERIAL PORT ]
END
[ SERIAL PORT ]
Even
XON/XOFF
DON'T USE
SPEED:
DATA BIT:
STOP BIT:
PARITY:
HANDSHAKING:
PRINTER:
DISPLAY TIME 4 SEC.
[ OPENING SCREEN ]
END
[ OPENING SCREEN ]
5 6 7 8 9 - CLR
0 1 2 3 4 ENT