Specifications

Changeover of Display Screen (FX-PCS-DU/WIN-E) 19
19-1
19. Changeover of Display Screen (FX-PCS-DU/WIN-E)
Chapter 18 describes how to change over two or more screens.
Screen changeover can be arbitrarily specified using operation keys in the GOT or from the
PLC.
19.1 Outline of changeover of display screen
In the GOT, up to 500 screens can be created. A number from 0 to 499 is assigned to each
screen.
A screen to be displayed next after the currently displayed screen should be specified using
operation keys in the GOT or from the PLC.
Not only user screens (No. 0 to 499) but also system screens (No. 1001 to 1030) in the
“ALARM MODE” or “OTHER MODE” can be displayed.
#
##
#
Important point
1) Creation of user screen No. 0
In the screen mode screen No. 0 is always displayed immediately after the power is turned
on.
Accordingly, screen No. 0 should be created. If screen No. 0 is not registered, the error
message "DISPLAY SCREEN IS NOT AVAILABLE." is displayed.
2) Screen numbers may not be consecutive.
Screen Nos. may not be consecutive in such a way as "0, 1, 2, 3 . . ."
When there is a possibility that some screens may be inserted in the future, inconsecutive
screen numbers can be used.
However, it is recommended to use consecutive screen numbers because mistakes may be
reduced in screen changeover.
Screen changeover
specified from G O T
(o p e ra tio n k e y ) o r P L C
Graphic Operation Terminal GOT-F900