Specifications

Graphic Operation Terminal GOT-F900 Introduction 1
1-12
*1 When using the communication unit, use it with the setting of CPU direct connection.
*2 Set to Direct connection to CPU when using the communication unit.
• In the case of F933GOT and F943GOT, connection to a PLC is limited to RS-232C
communication.
Be careful when looking at the table.
• For the method of wiring to a PLC, refer to "GOT-F900 SERIES HARDWARE MANUAL
(CONNECTION).
S7-200/300/400
Series manufactured
by Siemens AG
$%%%
The S7-300/400 is supported in the
following versions.
F930GOT and F933GOT, V3.00 or
later should be used.
F930GOT-K any version may be
used.
F940GOT and F943GOT, V5.00 or
later should be used.
F940WGOT, any version may be
used.
Following versions should be used
for S7-200:
F930GOT and F933GOT, V4.30 or
later
F930GOT-K any version may be
used.
F940GOT, and F943GOT, V6.30 or
later
F940WGOT, V1.30 or later
Microcomputer
board
Select a communication procedure
according to the GOT (RS-232C/RS-422).
When connecting two or more units
F930GOT and F933GOT, V3.00 or
later should be used.
F930GOT-K any version may be
used.
F940GOT and F943GOT, V5.00 or
later should be used.
F940WGOT, any version may be
used.
Applicable PLC
Direct connection
to CPU
Computer link
Upper link
Remarks
RS-232C RS-422 RS-232C RS-422