Specifications

Graphic Operation Terminal GOT-F900 Introduction 1
1-7
1.4 System configuration
The method of connecting the GOT to PLC and peripheral units is described below.
1.4.1 Connection of GOT with peripheral units
The figure below shows the system configuration required to use the GOT with peripheral
units.
F920GOT-K, F930GOT, F930GOT-K,
F933GOT, F940GOT, F943GOT and
F940WGOT
g
raphic operation terminals
·Data transfer cable FX-232CAB-1
(
3m
(
9' 10"
))
(
when the RS-232C port in the PC is 9-pin
t
y
pe
)
·Data transfer cable FX-232CAB-2
(
3m
(
9' 10"
))
(
when the RS-232C port in the PC is half-
pitch, 14-pin t
y
pe
)
·Data transfer cable F2-232CAB-1
(
3m
(
9' 10"
))
(
when the RS-232C port in the PC is 25-pin
t
y
pe
)
The ROM is attached to
F9GT-40UMB and inserted
into the connector on the
back of the GOT.
(
F940GOT and F943GOT
onl
y)
Data transfer
cable
F2-232CAB-1
(
3m
(
9' 10"
))
·General-purpose personal computer
(
screen creation software
)
FX-PCS-DU/WIN-E or GT Desi
g
ner
(
Not available in the F920GOT-K.
)
·Printer
Bar code reader
<General-purpose printers>
ESC/P
Printer equipped with
RS-232C interface
Prints out samplin
g
data,
alarm histor
y
, alarm
messa
g
e and screen
hard cop
y
·EPROM memor
y
User screens can be stored
usin
g
a
g
eneral-purpose
ROM writer.
(
FX-EPROM-4M
)
FX-PCS-DU/WI N-E is used
to put screen data in the form
of ROM chips.
(
In the case of GT Desi
g
ner,
data cannot be saved on to a
ROM chip.
)
RS-422 or RS-232C
communication
RS-232C communication
RS-232C communication.
(
Not available in the
F920GOT-K.
)
PLC