Specifications

Graphic Operation Terminal GOT-F900 Screen Hard Copy Function 14
14-3
14.3.3 Hard copy output signal (GT Designer)
The hard copy output signal for the display screen is assigned through system information
(when GT Designer is used).
The hard copy output signal cannot be used when FX-PCS-DU/WIN-E is used.
GT Designer
When printing is started by a trigger or touch key, the bit of the following system information
turns ON. (Refer to "6.6.2 System information".)
For example, when D20 is assigned as the head write device (refer to 6.6.2.), b7 of D24 turns
ON.
When printing is completed or an abort command (trigger or touch key) is given, this bit turns
OFF.
• Printing is performed at the following timing.
*1 If a printing start command is given while printing is performed, it is ignored and new
printing is not performed.
System information
Hard copy output signal
b7 of "word device specified as head write device +4" becomes ON.
Start tri
gg
er or start
touch switch
Printin
g
is started.
Hard cop
y
output
si
g
nal ON
Abort tri
gg
er or abort
touch switch
D24 b7 ON
Printin
g
is performed.
Printin
g
is
performed.
Printin
g
is
aborted.
*1