Specifications

Graphic Operation Terminal GOT-F900 Other MODE 12
12-7
12.5 ENTRY CODE
When an entry code is registered in the PLC, changes to the set values of timers and counters
in the screen mode and monitor mode are forbidden. However, the current values can be
changed. (Only the UNLOCK function is available in the F920GOT-K.)
ENTER
Registers an entry code to the PLC.
This entry code is shared by other peripheral units. Enter an 8-digit (FX Series) or 6-digit (A
Series) hexadecimal numeric.
INPUT ENTRY CODE:
&&&&&&&&
The entry code becomes effective when the power of the GOT is turned OFF, then turned ON
again.
DELETE
Deletes the existing entry code.
The existing entry code can only be deleted after it was first been entered in the unit.
UNLOCK
Temporarily unlocks the existing entry code. (The entry code is kept registered.)
The unlock function is valid until the power of the GOT is turned OFF.
Note:
When you have forgotten the existing entry code, execute "all clear" in a peripheral unit.
However, have in mind that all of the data including programs in the PLC are deleted by
"all clear". It is recommended not to forget the entry code.
*
**
*
Basic operation
[ ENTRY CODE ] END
ENTER
DELETE
[ ENTRY CODE ]
UNLOCK
[ ENTRY CODE ] END
ENTER
INPUT ENTRY CODE
Screen1 Screen2
0 0 0 0 0 0 0 0
CDEFCLR
89
ENT
B
4567
0123
A
OTHER MODE
screen is displayed.
ENTRY CODE
Section 5.3
Select "ENTRY CODE".
Screen 1
ENTER 0 to F
Enter an entry
code. Screen 2
ENT
Executes
registration.
DELETE 0 to F
Enter the existing
entry code. Screen 2
ENT
Executes
deletion.
UNLOCK 0 to F
Unlock the existing
entry code. Screen 2
ENT
Executes
unlocking.