Specifications

Graphic Operation Terminal GOT-F900 Alarm MODE 10
10-4
2) Screen changeover (changeover of base screen)
If "screen changeover" is selected, when a specified alarm device turns ON from OFF, a
user screen displayed at that time in the screen mode is changed over to a specified screen
When the GT Designer is used, a specified screen is displayed when the DETAIL key or
#
key (in the F920GOT-K) is pressed.
The display can be returned from the specified screen to the previous screen using the
following procedure.
(When the GT Designer is used, a specified screens are displayed when the DETAIL key or
the
#
key is pressed.)
• In the case of the FX-PCS-DU/WIN-E
Set "Destination Screen" to "DU memory" in the "Change Screen" object of the changed
screen.
• In the case of the GT Designer
Set "Next screen" to "Previous" in "Base switching Screen" of the changed screen.
3) Printing (Setting is available only in the FX-PCS-DU/WIN-E.)
When an alarm has occurred, the date of occurrence and a corresponding alarm message
can be printed.
Alarm messages should have been entered in half-width characters. The communication
condition of the printer should have been set in "SERIAL PORT" in "SET-UP MODE" in the
GOT. (Cannot be printed when using the F920GOT-K)