Specifications

Graphic Operation Terminal GOT-F900 Sampling MODE 9
9-3
9.2 Outline of sampling condition setting
The sampling condition should be set before starting.
This section describes the outline of the sequence and contents of setting.
For the operating procedures, refer to the next page and later.
*
**
*
Basic operation
• On the SET CONDITION screen, "SAMPLE COND.", "START COND.", "END COND." and
"SAMPLING DEV." can be set. Each item functions as a touch key. When a desired item is
touched, the corresponding setting screen is displayed.
a)SAMPLE COND. (Section 9.2.1)
• Set the sampling condition. When the condition set
here is satisfied, data on a specified data register is
acquired.
The sampling condition can be set to "DEVICE" or
"CYCLIC".
DEVICE : Data is acquired when a bit of X, Y, M, S, T
or C turns ON (OFF
(
ON) or OFF (ON
(
OFF).
CYCLIC : Data is acquired at a constant time interval.
b)START COND. (Section 9.2.2)
• Set the timing to start sampling.
DEVICE : Sampling is started when a bit of X, Y, M, S,
T or C turns ON (OFF
(
((
(
ON) or OFF (ON
(
((
(
OFF).
TIME : Sampling starts at a specified date and time
(date, hour, minute and second).
The time set in "SET TIME SWITCH" in
"OTHER MODE" is used as the reference.
• If the start condition set here is not satisfied, sampling
is not performed even if the sampling condition is
satisfied.
* When the start condition has not been set, specify
M8000 (FX Series) or M9036 (A Series) which is
always ON while the PLC is running.
SAMPLING MODE
screen is displayed.
The SET CONDITION
screen is displayed.
SET CONDITION
Section 5.3
Select "SET CONDITION".
The screen shown
below is displayed.
[ SET CONDITION ] END
SAMPLE COND.
SAMPLING DEV.
START COND.
END COND.
a)
b)
c)
d)
DEVICE
M 0
DEVICE
M 0
D100
OFF
[ SET CONDITION ]
NUMBER
0
ON
→
OFF ON
→