Specifications

Graphic Operation Terminal GOT-F900 HPP Mode 8
8-13
#
##
#
Important point
1) In setting the memory capacity, the allowable setting range varies depending on the
memory of the connected PLC main body (automatic recognition).
2) In setting the file register, the allowable setting range of the number of blocks varies
depending on the selected memory capacity.
(One block occupies 500 steps. Up to 14 blocks are allowed when the memory capacity is
set to 16 K steps.)
3) In setting the latch range, the allowable setting range of device No. varies depending on the
connected PLC main body.
4) Change of each parameter is executed when the END key is pressed.
5) Change of parameters is enabled only while the PLC program is stopped.
6) Change of parameters is enabled only while a RAM or EEPROM (whose write-protect
switch is set to OFF) is used as the memory in the PLC main body.
7) After entering a numeric, press the CLR key to cancel the entered value.