Specifications

Graphic Operation Terminal GOT-F900 USER SCREEN MODE 7
7-22
7.7 Data change using key pad (F920GOT-K and F930GOT-K)
Values of "Numerical Input" and "Ascii Input" (0 to 9) can be changed using the key pad in the
F920GOT-K, or using the touch keys or the key pad in the F930GOT-K.
This paragraph explains the data change operation using the key pad.
For the data change operation using the touch keys in the F930GOT-K, refer to section 7.6.
7.7.1 Data change operation using key pad
The data change operation is valid for the following displayed objects:
• "Number" and "Ascii" created using the FX-PCS-DU/WIN-E
In this case, it is required to select "Data Changeable" in advance for "Number" or "Ascii" to
be changed.
• "Numerical Input" and "Ascii Input" created using the GT Designer
- "SET" key: displays the cursor.
When the SET key is pressed, the cursor is displayed
and data change is enabled.
The cursor is displayed in a data change target object
located in the upper left position. (Only objects
satisfying the operation condition are regarded as data
change targets.)
-"
"
", "
#
", "
!
" and "
$
" keys: Select the target object.
By using these keys, select a target object whose data
is to be changed.
- "0" to "9", "
–
" and "
•
" keys: Enter a numeric value.
By using these keys, enter a numeric value.
Use the "
–
" key to input a negative value. Use the "
•
"
key to input the decimal point.
- "ESC" key: Cancels the data change operation.
When this key is pressed, the previous numeric value
before change is displayed again.
- "ENT" key: Determines the input numeric value.
When this key is pressed, the input numeric value is
determined and written to the PLC.
- "DEV" key: Not used.
Cursor displa
y
***
DEV
ENT
$
1 2 3
4
***
0
-
321
4 5 6
7 8 9
SET
ESC
!
"
***
***
#
5 6 7 8
4 3 2 1
8 7 6 5