Specifications

Graphic Operation Terminal GOT-F900 USER SCREEN MODE 7
7-18
Basic operation
• On the same screen a key window will always open in the same position as it was last
closed. If the screen is displayed for the first time, the key windows will appear in its set
position.
• If the screen is changed over and back again, the key window will appear in its set position.
• On a screen for which the key window initial position is not set, the window is always
displayed in the lower right corner.
• When a key window’s initial position is set to where it is protruding from the screen, the
initial position start coordinate is corrected so that the entire key window can be displayed
on the screen. (Refer to the figure below.)
Zero point
(
0, 0
)
X:0
Y:100
When "X: 0, Y: 100" are set
The zero point in this coordinate s
y
stem is located at
the upper left corner of the screen.
•
"X: 300, Y: 220" are set
Coordinates are
automaticall
y
corrected
to "X: 160, Y: 100"
When "X: 160, Y: 100" or larger coordinates are set
In the above settin
g
, the
ke
y
window is protrudin
g
from the screen.
•
The upper left corner coordinates are
automaticall
y
corrected so that the
entire ke
y
window can be displa
y
ed on
screen.
•