Specifications
Graphic Operation Terminal GOT-F900 Creation of Display Screens 6
6-28
6.6.2 System Information (setting in GT Designer)
The following word devices can be specified as System Information devices for read and write.
• Read devices (PLC to GOT):
One or two 16-bit word devices are occupied.
(No devices are set when the GOT is shipped from the factory. The number of occupied
devices can be changed using the screen creation software.)
• Head of specified word devices:
Reads the GOT information to bits 0 to 8 (b0 to b8).
"Head +1":
Specifies the recipe number to be read from/written to the PLC using the recipe function.
[ When data register D10 is assigned ]
*1 In F930GOT-K: From the first product, In F930GOT and F933GOT: V4.00 or later,
F940GOT, F943GOT: V6.00 or later,
F940WGOT: V1.00 or later
In F920GOT-K, the entry code input keyboard is displayed automatically without regard
to the status of the system information.
• Write devices:
Five 16-bit word devices are occupied.
(Fifteen word devices are occupied in principle in the screen creation software. However,
write devices not used in the GOT can be used as general word devices.)
No devices are set when the GOT is shipped from the factory.
• Head to "Head +2" of specified word devices: Store the screen numbers currently displayed.
"Head +3": Stores the object ID whose input is completed (Numerical Input, Ascii Input).
"Head +4": Turns ON/OFF its bits 0 to 8 (b0 to b8) to control the GOT.
Data register Contents of control
D10
b0 When set to ON from OFF, clears the alarm history of the GOT.
b1
When set to ON, extinguishes the backlight of the display screen after the specified
time.
b2 When set to ON from OFF, clears the sampling data acquired in the sampling mode.
b5
When set to ON, nullifies bar cod inputs and clears the data read by the GOT while the
bar code reader is connected.
b6 When set to ON, sets to OFF the bit 5 of the write device D
"
+4.
b8
When set to ON, automatically displays the keyboard for inputting the password when
a screen at higher security level is displayed.
*1
D11
Specifies the recipe No. to be read from and written to the PLC by the recipe function.
Set a recipe number of a recipe file created by the GT Designer subtracted by "1".
Example: When reading or writing the recipe file number 1, write "0" to D11.