Operation Manual

−43−−42−
■
Operation method of various setting
1.
When tapping the [Night tariff setting] on the [Administrator
settings] menu screen, the [Night tariff setting] screen is
displayed.
If changing [Start time] or [End time] displayed, tap
Change button.
If the power consumption in day time and in night time
is not distinguished, tap
Set button and after tapping
Valid button to switch it to Invalid , tap Set button.
2.
Set the [Start time] of [Night tariff setting].
Adjust the [Start time] to the desired time (at 10 min
intervals) by tapping
▲ ▼
buttons.
After adjusting [Start time], tap
Set button. The [End
time] setting screen is displayed.
Adjust the [End time] to the desired time (at 10 min
intervals) and
Set button.
1.
When tapping the [HP unit selection] on the
[Administrator settings] menu screen, the [HP unit
selection] screen is displayed.
If change the HP unit displayed on RC, select the HP
unit to be displayed and tap
①
Set button.
If not selecting the HP unit displayed on RC, tap
②
Valid button and switch to Invalid . After that, tap
①
Set button.
In case of
Invalid setting, the HP unit to be displayed
is selected automatically.
On the [HP unit selection] screen, up to 5 units can be
displayed. If more than 6 units are connected to one
remote control, when tapping
Next button, the 6th and
the subsequence HP units are displayed.
■
How to set night tariff
Regarding the power consumption for day time and for night time displayed on the [More
information] screen, the time zone to integrate power consumption can be changed.
■
How to select the HP unit displayed on RC
The heat pump unit to display its operation state on the TOP screen is selectable.
1
2