Specifications

4 - 14 4 - 14
4. SETUP AND PROCEDURES PRIOR TO OPERATION
4.7.3 Inserting and removing the antenna cable
When inserting or removing an antenna cable, follow the procedures below.
(1) Insertion Method
1) Hold the section of the connector that secures the cable and insert the
connector with the white dot facing upward.
2) Push the connector straight in until the connector locks.
Section tha
t
s
ecures the cable
Ring section
Point
The connector will not lock if you push the ring section. Be sure to hold and push
the section that secures the cable.
(2) Removal method
1) Hold onto the ring section and pull straight back.
Section tha
t
s
ecures the cable
Ring section
Point
The connector cannot be removed by holding and pulling the section that secures
the cable. Do not pull the cable with force.
CAUTION
 Do not insert or remove an antenna cable with the
power ON. Doing so results in the risk of failure.