Specifications

4 - 6 4 - 6
4. SETUP AND PROCEDURES PRIOR TO OPERATION
4.4 Setup and Procedures Prior to Operation
Start
Verify the specifications of the RFID interface
Install the ID tag.
(Refer to the OMRON User's Manual.)
Wire the data link cable, execute wiring to the
external power supply terminal, and connect
and install the amplifier and antenna.
(Refer to Sections 4.6 and 4.7, the OMRON
User's Manual, and the CC-Link Master Module
User's Manual.)
controller CPU, reset the CPU, and run the
CPU using the written
parameters.
number selection switch, and mode switch
(TEST mode). (Refer to Section 4.5.)
C
(Refer to Section 4.5.)
Operation
(Refer to Chapter 6.)
Verify operation using the LEDs. If the data link
is implemented normally, the L RUN LED will
turn on and the L ERR. LED will remain off.
measurement, and noise level measurement in
TEST mode. (Refer to Section 5.1.3.)
Set the mode switch to RUN mode.
(Refer to Section 4.5.)
Turn ON the system power supply.