Specifications

4 - 5 4 - 5
4. SETUP AND PROCEDURES PRIOR TO OPERATION
DIN rail bracket
7. Press in the direction opposite that indicated by the arrow
on the DIN rail bracket and tighten the screw using a driver.
DIN rail bracket
8. Install the DIN rail bracket to the right side of the module
following the same procedure. When installing the DIN rail
bracket to the right side, the DIN rail bracket is installed
upside down. Be careful during handling.
Point
Do not install the module by sliding the module from the end of the DIN rail. Doing
so results in the risk of damaging the bracket on the module rear side.
(2) Removal procedure
1. Remove the DIN rail brackets. Remove the brackets by
following the installation procedure in the reverse order.
2. While pressing the DIN rail installation hook with a flathead
screwdriver, pull the lower part of the module and remove
the module from the DIN rail.
(3) Applicable DIN rail model names (JIS C 2812 compliant)
TH35-7.5Fe
TH35-7.5Al
(4) DIN rail installation screw spacing
When installing the DIN rail, tighten the screws at a pitch of 200mm or less.
(5) DIN rail bracket
Use a bracket that can be mounted to the DIN rail.