Specifications

1 - 2 1 - 2

1. OVERVIEW

1.2 RFID Interface Module Features

The following describes the features of the RFID interface module.

(1) The RFID interface module enables OMRON RFID system V680 series connection

to CC-Link.

This product can connect the OMRON RFID system V680 series to CC-Link,

achieving distributed control at the distance up to 1200 m (at the 156-kbps

transmission speed). Furthermore, it is possible to construct an RFID sensor

system architecture that uses a rich group of CC-Link products.

(2) The module can read and write a maximum of 122 bytes

of data at one time.

*1. In the case of remote net Ver.2 mode, two occupied stations, and an octuple

expanded cyclic setting.

(3) The module permits usage of both OMRON RFID system V680 series separate-type

and amplifier built-in type antennas.

(4) The module is provided with various test functions as standard.

The communication test function allows you to check whether or not communication

with an ID tag is possible without operating the sequence program.

The distance level measurement function measures the distance (level) between

the antenna and ID tag with respect to the communication area. The function

allows you to check the measurement results in seven stages, 00 to 06.

The noise level measurement function measures the noise level in the area

surrounding the antenna installation location.

(5) The module allows you to select a mode in accordance with a variety of systems.

Remote net Ver.2 mode: Select this mode when you want to construct a new

system. The mode allows you to combine the module with an applicable master

module and increase the number of connected remote device stations to 42,

maximum.

Remote net Ver.1 mode: This mode is fully compatible with conventional remote

network modes. Select this mode when system expansion is not required.

Remote net additional mode: Select this mode when you want to add a version 2

compatible slave station to the conventional version 1 system.

(6) The module allows you to simply develop programs by downloading an FB (function

block) library that can be used with Mitsubishi Electric MELSOFT GX Works2 from

the Mitsubishi Electric Corporation FA site and FA related product site (MEEFAN).

(Supported by GX Works2 Japanese version only)

(7) The Mitsubishi Electric iQ Sensor Solution (iQSS) makes it possible to further

strengthen the linkage with the programmable controller, graphic operation terminal,

and engineering software, and achieve simple startup, sensor monitoring, and

simple programming.

(Supported by GX Works2 Japanese version only)