Electric Heat Kit Installation Manual
Table Of Contents
- Electric Heat Kit
- Table of Contents
- CHECK LIST AFTER INSTALLATION
- Dimensions
- 1. Electric Heat Kit Models
- 2. Electric Heat Kit Accessories
- 3. Safety precautions
- 4. Installing the Electric Heat Kit
- 4.1 Read the safety precautions section of the Multi-Position Air Handler before installing the electric heat option.
- 4.2 Setting proper external static pressure.
- 4.3 Enabling Electric Heat
- 4.4 Operation Mode
- 4.5 Attaching the enclosure to the Air Handler
- 4.6 Proper Support in the Horizontal Position for the Multi-Position Air Handler with Electric Heat Kit:
- 4.7 Rotating circuit breaker orientation for Horizontal Left Installations:
- 5. Electrical Schematics
4.5.H. Reinstall the Heater Section into the Heater Enclosure. When inserting the Heater Section into the Heater
Enclosure, be sure the frame rods are inserted into the holes provided in the Heater Enclosure to properly support the
Heater Section. Secure the Heater Section to the Heater enclosure with the (5) screws removed earlier
. Next, for MVZ,
PVA & PVFY, remove the Electric Panel from the Air Handler to expose the electrical boards. For SVZ, remove
"BLOWER" panel to expose the electrical boards.
Frame Support
The frame of the heater will insert into
the hole in the back of the electric heat
enclosure. This provides proper support
for the electric heater.
SVZ
SVZ
PVFY/PVA/MVZ
The frame of the heater will insert into
the hole in the back of the electric heat
enclosure. This provides proper support
for the electric heater
Frame Support
Frame Support
PVFY/PVA/MVZ
Electrical panel removed to expose
control boards
Filter and blower panel
removed to expose control
boards
Electric Heat Kit
Specifications are subject to change without notice. 22 © 2018 Mitsubishi Electric US, Inc.