Electric Heat Kit Installation Manual
Table Of Contents
- Electric Heat Kit
- Table of Contents
- CHECK LIST AFTER INSTALLATION
- Dimensions
- 1. Electric Heat Kit Models
- 2. Electric Heat Kit Accessories
- 3. Safety precautions
- 4. Installing the Electric Heat Kit
- 4.1 Read the safety precautions section of the Multi-Position Air Handler before installing the electric heat option.
- 4.2 Setting proper external static pressure.
- 4.3 Enabling Electric Heat
- 4.4 Operation Mode
- 4.5 Attaching the enclosure to the Air Handler
- 4.6 Proper Support in the Horizontal Position for the Multi-Position Air Handler with Electric Heat Kit:
- 4.7 Rotating circuit breaker orientation for Horizontal Left Installations:
- 5. Electrical Schematics
4.5.C. Locate the rear flange of the supply side of the multi-position air handler
.
PVFY/PVA/MVZ
SVZ
4.5.D. Locate the angled tab that will secure the enclosure to the top of the multi-position air handler
. On the bottom of
the enclosure toward the back is the tab. Notice the gap between the angled tab and the back of the enclosure. This is
extremely important for installation.
Insert rear flange of
air handler's supply into the
gap at the back of the
electric heat enclosure
Detail
Detail(0.500)
Angled Tab
Bottom of Electric Heat Enclosure
A
Rear flange
Electric Heat Kit
Specifications are subject to change without notice. 19 © 2018 Mitsubishi Electric US, Inc.