Electric Heat Kit Installation Manual
Table Of Contents
- Electric Heat Kit
- Table of Contents
- CHECK LIST AFTER INSTALLATION
- Dimensions
- 1. Electric Heat Kit Models
- 2. Electric Heat Kit Accessories
- 3. Safety precautions
- 4. Installing the Electric Heat Kit
- 4.1 Read the safety precautions section of the Multi-Position Air Handler before installing the electric heat option.
- 4.2 Setting proper external static pressure.
- 4.3 Enabling Electric Heat
- 4.4 Operation Mode
- 4.5 Attaching the enclosure to the Air Handler
- 4.6 Proper Support in the Horizontal Position for the Multi-Position Air Handler with Electric Heat Kit:
- 4.7 Rotating circuit breaker orientation for Horizontal Left Installations:
- 5. Electrical Schematics
4.5 Attaching the enclosure to the Air Handler
4.5.A. Remove the Front Cover as well as the Heater Section of the Heater Enclosure. The heater section is secured
by (5) screws. Use a 5/16” hex socket or Philips for all screws.
HEATER ENCLOSURE
HEATER SECTION
FRONT COVER
4.5.B. Remove the (4) pieces of foam insulation from the outlet flange on the multi-position air handler and cut the
remaining foam so there are no obstructions in the outlet opening.
Also, remove the top (2) knockouts from the Air Handler and install the two grommets included in the Electric Heat Kit
accessory bag in the air handler
.
SVZ
PVFY/PVA/MVZ
Remove (4) pieces of insulation
from supply duct
Remove (4) pieces of insulation
from supply duct
Remove (2) knockouts
Install (2) provided grommets
Remove (2) knockouts
Install (2) provided grommets
Electric Heat Kit
Specifications are subject to change without notice. 18 © 2018 Mitsubishi Electric US, Inc.