Electric Heat Kit Installation Manual
Table Of Contents
- Electric Heat Kit
- Table of Contents
- CHECK LIST AFTER INSTALLATION
- Dimensions
- 1. Electric Heat Kit Models
- 2. Electric Heat Kit Accessories
- 3. Safety precautions
- 4. Installing the Electric Heat Kit
- 4.1 Read the safety precautions section of the Multi-Position Air Handler before installing the electric heat option.
- 4.2 Setting proper external static pressure.
- 4.3 Enabling Electric Heat
- 4.4 Operation Mode
- 4.5 Attaching the enclosure to the Air Handler
- 4.6 Proper Support in the Horizontal Position for the Multi-Position Air Handler with Electric Heat Kit:
- 4.7 Rotating circuit breaker orientation for Horizontal Left Installations:
- 5. Electrical Schematics
NOTE
For PV
A-A·AA4(7), MVZ -A·AA4(7) and SVZ-KP-NA models, electric heat lockout is available as a
separate accessory. See accessory, ETC-211000-MIT.
MVZ-A·AA4(7), SVZ-KP-NA and PVA-A·AA4(7) models:
When installing an electric heater kit for PVA-A-AA4 and MVZ-A-AA4, mode “23” needs to be set to “2”. When installing an
electric heater kit for PVA-A-AA7, MVZ-A-AA7 and SVZ-KP-NA models, mode “11” needs to be set to “2”. This enables the
heater to operate.
Electric Heat Kit
Specifications are subject to change without notice. 15 © 2018 Mitsubishi Electric US, Inc.