User`s guide

Hardware
42 Mitsubishi Electric, MA00758A
3.7.9 Replacing the Backlight
To following is needed:
– A new backlight, see the Available Spare Parts list.
– A torx T10 screwdriver
– A screwdriver Phillips size 0 or 00 (only for E1151).
E1012, E1022, E1032, E1041, E1043, E1060, E1061, E1062, E1063,
E1070 and E1071
If the backlight is broken on a panel listed above, the entire display must be replaced.
To replace the display you will need a new display including plastic frame and display
cable, see the Available Spare Parts section. For information about changing the dis-
play See Replacing the Display/Display Cable section.
E1100
To replace the backlight of E1100, follow the steps 1-5 in section Replacing the Rear
Cover for E1100. Then follow the steps below:
1. Gently move the backlight diagonally in direction from the display center to
release the snap-in closure that keeps the backlight in place.
2. Remove the backlight from the display.
3. Insert the new backlight. Be careful not to pull the cables of the new backlight
when inserting it, since pulling the cables will damage the backlight.
4. Re-assemble the complete operator panel.
Note:
All lamps in the display must be replaced at the same time.
Note:
Make sure you have adequate ESD protection.
backlight snap lock
backlight
connectors