User`s guide

Hardware
Mitsubishi Electric, MA00758A 41
E1070, E1100, E1071, E1101 and E1151
The following is needed:
– A new battery, see the Available Spare Parts list.
– Glue Gun: Jet-Melt TCQ, manufacturer: 3M
– Melting Glue: 3748 V-O, manufacturer: 3M
Follow the steps below to replace the battery:
1. Power off the operator panel.
2. Follow the instructions under Replacing the Rear Cover to remove the rear cover.
3. Flip the back cover (the CPU board and the battery are mounted on the rear side
of the back cover).
CPU board with battery holder on the rear side of the back cover
4. If the battery is glued with melting glue, remove the glue before carefully remov-
ing the battery from the battery holder.
5. Carefully fit the new battery into the battery holder. Make sure the plus sign on
the battery is set towards the plus sign on the holder.
6. Glue the battery to the battery holder with melting glue.
7. Re-assemble the operator panel in reverse order.
Note:
The removed lithium battery should be recycled.
battery holder