User`s guide

Hardware

26 Mitsubishi Electric, MA00758A

3.7.3 Replacing the Rear Cover

The following is needed:

–A new rear cover.

– A torx T10 screwdriver.

E1012, E1022, E1032, E1041, E1043, E1060, E1061, E1062 and

E1063

To replace the rear cover you will need a new rear cover, see the Available Spare Parts

section.

Then follow the steps below:

1. Power off the operator panel.

2. Follow the instructions Replacing the Battery to remove the battery.

3. Remove the rear cover of the operator panel by loosening the 4 torx screws.

Illustration of E1012 and E1022

Illustration of E1032

Illustration of E1060/E1061/E1062/E1063

Note:

Make sure you have adequate ESD protection.

1 2 3 4

ON DIP

4 x torx screws