Specifications

5. CONNECTION OF UNIT
5.1 Names of Each Part
I-10
5. CONNECTION OF UNIT
The methods for connecting to each unit and device are briefly explained in this chapter.
5.1 Names of Each Part
(1) 24VDC input connector
(2) Connector 1 for encoder (speed signal)
connection (Note)
(3) Connector 2 for encoder (speed signal)
connection (Note)
(4) Station No. setting rotary switch
(5) RUN-STOP slide switch
(6) Programming unit connection connector
(7) Digital signal input connector
(8) Digital signal input connector
(9) Digital signal output connector
(10) Remote I/O connection connector
(11) Remote I/O connection connector
(Note) The encoder speed signal is connected
via the spindle amplifier. As there is no
power supply, the encoder cannot be
directly connected to the connectors
ENC1/ENC2.
Front view
ENC1 (2)
ST No. (4)
DO-L (9)
DI-L (7)
0
1
2
3
4
5
6
7
8
9
A
B
C D
E
F
ST No.
POWER
RUN
CPU-E
ST OP
RUN
PROG. PORT
DI-R DI-L
DO-L
RI O
ERR1
ERR2
ENC1 ENC2
DCIN
DCIN (1)
ENC2 (3)
PROG.PORT (6)
DI-R (8)
RUN/STOP (5)
Bottom view
RIO1 (10)
RIO2 (11)
RIO1 RIO2