Instruction manual

ENGLISH

Step

5 Turn ON the MAIN switch on the rear panel and

then press the POWER button on the front panel of

this recorder.

Step

6 After the recorder boots up and the buzzer sounds,

press the TEST button.

• The management information deletion function is

activated and the HDD A or B indicator starts blinking.

Upon completion of the deletion, the indicator

illuminates.

Step

7 Set the MODE rotary switch to the number

corresponding to the desired operation mode.

MODE rotary switch HDD operation mode

0 Do not use

1 Spanning

2 Mirroring

3 to F Do not use.

Step

8 Press the POWER button on the front panel and

then turn OFF the MAIN switch on the rear of this

recorder.

Step

9 Attach the front unit.

• Attach the unit and push it to the left.

Step

Fix the front unit with screw and close the front

door.

Step

Turn ON the MAIN switch on the rear of this

recorder.

Step

Initialize the HDD using the supplied software for

service.

Notice

• Note that when you initialize the HDD, the already

recorded data cannot be played any longer.

Before you initialize the HDD, check sufficiently that

there is no recorder having the same IP address in

the same network to prevent deleting the data in other

recorders unexpectedly.