Instruction manual

15
ENGLISH
Startup
Step
1 Turn ON the MAIN switch on the rear panel of this recorder.
Step
2 Check that the POWER indicator goes out and then press the POWER button on the front panel of the recorder.
Step
3 Initial setting - IP address setting
Set the IP address of this recorder using the special application software stored in the supplied CD.
• The default setting of the IP address is 192.168.0.100.
• A full-rights user (user ID: "root" password: "admin000") has been registered as factory-preset users. You can change the
password, however, the user ID cannot be changed.
Step
4 Operation
• To operate this recorder, the special client software is required. Refer to the instruction manual supplied with the client
software.
• Users can access the recorder from multiple PCs using the same password and user ID. Up to 3 sessions can access
simultaneously.
Specifi cations of this recorder
Connectable IP camera IP camera See the supplied sheet.
Compression format MPEG4
Maximum number of connectable IP
cameras
16
Make sure to set the total recording value to 7 Mbps or less.
(Example) When connecting 16 cameras: 0.4 Mbps x 16
Live image Live image display Available through the client software
Recording Compression format MPEG4 (Compressed by the connected cameras.)
Number of frames to be recorded Depends on the connected cameras and the specifi ed
recording rate.
Maximum number of frames to be
recorded (per channel)
25 frames/s / 30 frames/s
(Depends on the connected cameras.)
Image resolution 720 x 576, 640 x 480, 320 x 240, 160 x 120
(Depends on the connected cameras.)
Recording rate Up to 7 Mbps
Alarm recording Yes
Pre-alarm recording Yes (15 seconds at the maximum)
Tips
• Using the software stored in the supplied CD, you can make or check the settings of this recorder. For the usage, refer to
the instruction manual of the software.
1 NV100 IP-Address Setup (software for IP address setting)
2 NV100 Setting Tool (software for other settings)
3 NV100 System Tool (software for service)