Instruction manual

14
Connections (continued)
Caution in installing multiple recorders in an EIA rack
Follow the steps below to install the recorder in an EIA rack (occupying 2U space) using the rack mount adaptor (DX-RM3).
1 Remove the feet from the bottom of the recorder. (4 feet)
2 Fit the rack mount adaptor using the screws on both sides of the recorder. (2 screws on each side)
3 Secure the recorder to the EIA rack using screws.
Prepare appropriate screws for your rack.
Rack mount adaptor (DX-RM3)
Screws on the recorder (2 screws on each side)
Feet on the bottom of the recorder (4 feet)
Cable clamping
Step
1 Insert the supplied clamp band into the clamp hole
on the rear of the recorder.
•
The clamp hole is for the power cable.
Step
2 Run the cable to be clamped around the clamp
band as shown in the fi gure.
•
The rough side of the band should face up.
Step
3 Pull the end of the clamp band until it is tightened.