Instruction manual

INSTALLATION
6
(7) Set the node address before replacing the cover onto the inverter.
(Refer to page 7 for node address setting.)
(8) Next remove the option data port insert from the inverter cover. Then
replace the inverter cover, while making sure that the Modbus Plus
connector is aligned with the option data port window. Connect the
Modbus Plus cable to the inverter by plugging DB9-style male
connector into DB9-style female connector of the option unit, which
should be visible in the option port window.
(9) Please consult and adhere to standard Modbus Plus documentation
and specifications on the wiring and installation of Modbus Plus
network hardware, as provided by Schneider Automation.
Figure 4 : Installation
Cover
Modbus Plus
connector
FR-A5NM
M3×8 screw
(accesory)
DATA PORT
Modbus Plus connector
Option mounting
hole
To inverter GND terminal
Inverter
FR-A5NM
Inverter GND terminal
Slot 2
Slot 1
Slot 3
Control circuit
terminal block
Main circuit
terminal block