User`s manual

INP-TN5A0202-E 5-21
5.5 Address Map and Data Format
5.5
Address Map and Data Format
Programless communication module status
Contents Reading out/Writing data setting range Factory-set
value
Register No.
Setting fault 0101h: St. No. confi guration SW is invalid value
0102h: DIP SW is invalid value
0201h: PLC communication speed is invalid value
0202h: PLC communication data length is invalid value
0203h: MC protocol is invalid value
0204h: PLC communication inter-cycle is invalid value
0205h: PLC communication starting time is invalid value
0206h: PLC response monitoring time is invalid value
0207h: Number of PLC communication retry is invalid value
0208h: Connection method is invalid value
0209h: Number of connected units is invalid value
020Ah: Operation at PLC communication fault is invalid value
020Ch: MC protocol frame type is invalid value
0210h: Setting area device type is invalid value
0211h: Setting area device size is invalid value
0212h: Monitor area device type is invalid value
0213h: Monitor area device size is invalid value
0214h: Setting area detail (The 1
st
word) is invalid value
0215h; Monitor area detail (The 1
st
word) is invalid value
- 30232
Communication status with PLC
Contents Reading out/Writing data setting range Factory-set
value
Register No.
PLC error counter 0→1→
…
→65535→0→1→
…
times - 31001
PLC error code 0000h to 0042h:Error code of A compatible 1C frame
0100h: Command message timeout
0101h: Response message timeout
0102h: Sum check code error
0103h: Header format error
0104h: ASCII code error
0110h: Hardware failure 1
0111h: Hardware failure 2
0120h: Continuous reception error
7000h to 7FFFh: QJ71C24N error code
- 31002
PLC sending counter 0→1→
…
→65535→0→1→
…
times - 31003
PLC receiving counter 0→1→
…
→65535→0→1→
…
times - 31004
Inter-PLC communication
execution time monitor
0 to 65535 ms - 31007
PLC inter-cycle time over counter 0→1→
…
→65535→0→1→
…
times - 31008