User`s manual

INP-TN5A0202-E 5-13
5.3 PLC Communication Setting
MC protocol setting
Setting for the protocol type between a programless communication module and a PLC.
Refer to the parameter below.
Parameter Setting Range Unit
Factory-set
value
Attribute
MODBUS register No.
(Relative Address)
MC protocol
2: Type 2
4: Type 4
5: Type 5
None 5 R/W 40003 (0002h)
Note
Do not set other than "2, 4, 5".
When using 1:N connection, the settings of every connected programless communication modules should be the same.
Usable MC protocol is depends on your PLC. Confi rm it by your PLC's instruction manual. MC protocol frame types are also
different depending on selected MC protocol. Refer to "MC protocol frame types" parameter
5-17
for details.
●
●
●