User`s manual

INP-TN5A0202-E 5-7
5.2 Memory Setting
Setting area defi nition example
For example, when “Setting area device type” parameter is “00A8h (data register)”, “Setting area start address” parameter is
“1000”, and “Setting area device size” parameter is “712”, setting area is as follows.
System field
(1 word each)
Data field
Reading demand flag
Parameter setting
demand flag
Command setting
demand flag
System area 1
(Reserved)
According to
the setting
parameters'
registeration
(0 to 712)
D1000
D1001
D1002
D1003
D1004
D1715
Defined by “Setting
area device size”
Defined by
“Setting area
device type” or
“Setting area
start address”
Note
Check the specifi cations of the PLC used, when setting each parameter of the “Setting area device type”, the “Setting area
start address” and the “Setting area device size”.
If the reserved area is needed, set “0” to the “Setting area entry St. No.” parameter, and “0” to the “Setting area entry register
No.” parameter.
Even if setting each parameter of the “Setting area entry St. No.” parameter and “Setting area entry register No.” parameter
beyond the size set by “Setting area device size”.
Non-registerable parameter to the Setting area
Even if the parameter is within the entry setting range of the “Setting area entry St. No.” or the “Setting area entry register No.”,
the monitor parameters and parameter marked “*” in the “Entry ban” column of the “Setting/Monitor area register No.” (Control
module
5-51
, Event module
5-64
, Analog module
5-71
cannot be set. Do not set such parameters,
since they cannot be modify via programless communications.
●
●
●
“Setting area” fi eld