User`s manual

4-22
4.4 Command Setting Demand/Response Flag
INP-TN5A0202-E
Stop operation (Command: 0000h)
Command setting demand status is cleared for the programless communication module by setting “0000h” for the “command
setting demand fl ag”.
PLC
(2) “0000h” is set for the command setting
response flag and showed the command setting
demand flag is in the complying with demand state.
(1) If “0000h” is set for the command setting
demand flag, the command setting
demand will be cleared.
Temperature
control module
St.32
(When connected
max. units)
Temperature
control module
St.1
Device memory
Monitor area
System field
Data field
Setting area
System field
Data field
Programless
communication
module
Executing this command puts the programless communication module into the standby status for the command setting demand.
Note
When the command setting demand fl ag is not set to “0000h” (Stop operation), the command for the command setting
demand fl ag is not complied with. Set the value after reset the command setting demand fl ag to “0000h” (Stop operation) to
modify the value of the command setting demand fl ag.
During 1:N connection, each programless communication has a system fi eld and a data fi eld.
●
●