User`s manual

4-18
4.3 Parameter Setting Demand/Response Flag
INP-TN5A0202-E
4.3
Parameter Setting Demand/Response Flag
Setting command for the system fi eld “parameter setting demand fl ag” in the setting area enables the value of the data fi eld
to be written to the temperature control module parameter entered as the set parameter. The operation results are set for the
“parameter setting response fl ag” of the system fi eld in the monitor area.
Stop operation (Command: 0000h)
Setting "0000h" for the system fi eld "parameter setting fl ag" in the device memory setting area enables the value of data fi eld in
the setting area to stop being written to the temperature control module parameter entered as the setting parameter.
(2) Stop writing set value
Set value Set value
PLC
(3) When writing is completed,
“0000h” is set for the parameter
setting response flag
(2) Stop writing
set value
(1) If “0000h” is set for the parameter
setting demand flag, stop writing
command will be sent.
Temperature
control module
St.32
(When connected
max. units)
Temperature
control module
St.1
Setting area
field
Device memory
Monitor area
System field
Data field
Setting area
System field
Data field
Programless
communication
module
The programless communication module comes to be standby for the parameter setting demand with executing this command.
Note
When the parameter setting demand fl ag is not “0000h” (Stopped state), command for the parameter setting demand fl ag
is not complied. If modify the value of the parameter setting demand fl ag, set the value after reset the parameter setting
demand fl ag to “0000h”.
During 1:N connection, each programless communication has a system fi eld and a data fi eld.
●
●