User`s manual

4-14
4.2 Reading Demand/Response Flag
INP-TN5A0202-E
Read out once (Command: 0001h)
Setting “0001h” for the system fi eld “reading demand fl ag” in the device memory setting area enables the temperature control
module parameters and the memory values entered as the monitor parameters to be read out once to the device memory area
data fi eld in the device memory.
PLC
(3) If completed reading out,
“0001h” will be set to
the reading response flag.
(2) Read out the monitor
value once.
(1) If “0001h” is set for the
reading demand flag, the reading
command will be sent once
Temperature
control module
St.32
(When connected
max. units)
Temperature
control module
St.1
Reading data from each temperature control module
Monitor area
field
Monitor
value
Monitor
value
Device memory
Monitor area
System field
Data field
Setting area
System field
Data field
Programless
communication
module
After fi nish reading out, put the programless communication module reading demand into the standby by the stop operation
command.
4-13