User`s manual

3-23
3.6 Connection
INP-TN5A0202-E
Wiring for power supply
Terminal layout
Power terminals are on the base part of each module.
Wiring is same for the all modules.
The power supplies to all connected modules by connecting this terminal to the only one of them.
DC 24V (-)
Power terminal
DC 24V (+)
Note
Wiring to a terminal block, use crimp terminal (screw size: M3).
Use the screws in this product only.
Screw size on the terminal block: M3×7 (with square washer)
Clamp torque: 0.78N-m (8kgf-cm)
Apply power cable with allowable current capacity larger than total consumption current of all connected modules.
Power cable more than one should not be connected to power terminals.
When using AWG 16 cable, you should use the crimp terminal that material thickness is 0.9mm or less.
Use the power cables and crimp terminals indicated below for wiring.
Power cable size
Cable type Size
Power cable, output, others 0.25 – 1.25mm
2
(AWG22 to 16)
Crimp terminal size
Cable size Clamp torque
0.25 – 1.25mm
2
(AWG22 to 16) 0.8Nm
3.2mm
6.0mm or less
Round-shaped crimp terminal Y-shaped crimp terminal
3.2mm
6.0mm or less
* Material thickness
0.9mm or less
●
●
●
●
●