User`s manual

3-4
3.1 Installation Procedure
INP-TN5A0202-E
This setting is for performing communication between a programless communication module and PLC.
●
Communication setting
●
Connection method
Set “0 1:1 connection” for the connection method.
●
Connected units
Set “1” for the No. of connected units.
Register parameters of the temperature control module that reads/writes form PLC.
●
Memory setting
●
PLC communication setting
* When setting the parameters of a programless communication module, connect a parameter loader for
PUM directly to the loader communication port on the programless communication module.
Programless communication module setting
6
This command is for setting communication the communication behavior between a programless
communication module and PLC.
●
Programless communication behavior
Operation command by a programless communication module
8
This setting is for communication-related parameters for PLC or DIP SW setting.
See “User’s manual” of your PLC for details of setting
PLC setting
7
5-16
5-3
5-16
5-5 to 5-10
5-11 to 5-17
4-3 to 4-23
Continued from the previous page