User`s manual

3-3
3.1 Installation Procedure
INP-TN5A0202-E
3.1
Installation Procedure
The fl owchart below shows the setting procedure for startup via PUM parameter loader.
1:1 connection
Connection permission for an enhanced communication module should be set to "1: PUMC connected (RS-485 disable)" with
all temperature control modules of the system. (Control/Event/Analog module)
When setting parameters for a programless communication module, connect PUM parameter loader to it directly.
Confirm installation dimensions
●
External dimensions
Decide installation method
●
DIN rail mounting
●
Mounting with screws
Connect the temperature control module performs communication with PLC on the right of the programless
communication module.
●
Connecting modules
Installation
1
It is for power supply to the connection between a programless communication module and PLC, and a
programless communication module. Turn OFF all the power of the equipment or any other modules, when wiring.
●
Connection with PLC
●
Wiring for power supply
See “User's manual” of your PLC for wiring of PLC.
Wiring
2
Configure the St. No. of a programless communication module.
●
Configure St. No. to “0” by using the St. No. configuration switch on the front face.
Station number configuration
3
Prepare a PC where PUM parameter loader has installed and a loader connecting cable to connect PC, a
programless communication module and a temperature control module.
See “Parameter loader for PUM user’s manual”.
Loader soft preparations for PUM
4
Set the “enhanced communication module (PUMC) connection permission” parameter of the temperature
control module connected to a programless communication module to “1: PUMC connected (RS-485:
disable)”.
See Instruction Manual "Parameter loader for multi-loop module-type temperature controller (PUM)" for
PUM parameter loader connection method and parameter setting.
* When setting parameters of a temperature control module, connect PUM parameter loader directly to the
loader communication port on a temperature control module.
In the case of a single-unit connection, connect PUM parameter loader directly to a single unit, and in the
case of connection of connected units, connect PUM parameter loader directly to the module set as
"Master" with "connected modules master/slave setting" parameter.
Temperature control module setting
5
3-10
3-11
3-7
3-14
3-15
3-23
1-7

Go to the next page
•
•