User`s manual

5-64 INP-TN5A0202-E
5.7 Setting/Monitor Area Entry Numbers (Event I/O module)
5.7
Setting/Monitor Area Entry
Numbers (Event I/O module)
The table below shows the register numbers of an event I/O module, which are settable to each parameter of "Setting/Monitor
area entry St. No." and "Setting/Monitor area entry register No." of a programless communication module.
Note
Parameters marked "*" in the "Entry ban" column in the table can not be changed via programless communication modules.
Do not set them to each parameter of "Setting/Monitor area entry St. No." and "Setting/Monitor area entry register No."
Operation Parameters
Contents
Reading out/Writing data setting
range
Factory-set
value
Register No.
Entry
ban
RUN/Standby Switch 0: RUN
1: Standby
0 40021
DI output unlatch command 0: OFF
1: Unlatch
0 40022
DO output unlatch command 0: OFF
1: Unlatch
0 40023